Blue Chip Diesel Products
Blue Chip Low Fuel Pressure Warning Kit
This product is our best bargain to save you money and your injection pump. Know that your fuel pressure is above the critical number of 5 psi when the light is out. Our Low Fuel Pressure Warning Kit will also tell you when to change your fuel filter by restriction, not by time, which saves you money on filters. When the Low Fuel Pressure Light comes on every time during hard acceleration, change the fuel filter, and if it still comes on during hard acceleration, you need to replace your lift pump. This great product is a super easy, 15 minute installation.
Blue Chip Gear Puller
This neat little custom made tool makes removing the gear from the shaft of a VP44 injection pump a lot easier. It has bolts exactly the right length , so no harm is done, and is sized to save your knuckles from getting hurt by the fan shroud. It also works on all previous injection pumps on the B Series Cummins engines.
APPS - Accelerator Pedal Position Switch
This part fits all Dodge Diesel Trucks from 1998 ½ through model year 2003, both manual and automatic transmissions. This is the part of the TPS (Throttle Position Sensor) or APPS (Accelerator Pedal Position Switch) that actually fails. When you buy it from Chrysler they only sell it installed in the "Belcrank" at around $500 dollars, which is a waste of your hard earned money. Buy this OEM quality unit and install it in the belcrank and you will save lots of money.
OEM Replacement Lift Pump
This is the third generation and very latest design Carter Lift Pump made for Cummins. It performs much better than the “In Tank” unit that Dodge is now selling exclusively for far more money. Dodge doesn’t even list the OEM style lift pump anymore!
Blue Chip VP44 Injection Pump Cover
This problem solver product, with the bit below, are both included with every FMS or Fuel Management System we sell. The other good news is that it can be used with our Competitors' fueling style performance products to hide the solenoid connection on the Injection Pump. It insures a much better weatherproof connection to the injection pump solenoid wire. If you use this cover you can save your Bosch warranty on the Injection Pump, as they won't see the "Nick in the Wire" that is an automatic denial of your warranty. Simply remove this cover and replace it with the OEM metal pump cover before seeking warranty consideration, and you have a much better chance of satisfaction.
25 Torx Plus Tamperproof Bit
Most likely you will need this bit to remove and install the OEM pump cover and or the cover above..
IF YOU THINK YOU ALREADY HAVE THIS BIT, PLEASE COMPARE WHAT YOU HAVE WITH THIS PICTURE. THIS "TORX PLUS" HAS ONLY FIVE FLUTES, NOT SIX, AS IS A "TORX" BIT. ALSO BE SURE YOU HAVE THE HOLE IN THE MIDDLE TO BE TAMPERPROOF!